USB BLOCK 1.5.0 INSTALL
Now you may install it to a MicroSD card using `mix burn` or upload it Inode table size 19932 bytes (19.46 Kbytes)Ģ8.41% of uncompressed inode table size (70170 bytes)ĭirectory table size 23961 bytes (23.40 Kbytes)Ĥ0.38% of uncompressed directory table size (59334 bytes)īuilding /Users/elay15/projects/groxio/nerves/sensor_hub_poncho/sensor_hub/_build/rpi0_dev/nerves/images/sensor_hub.fw. Updating base firmware image with Erlang release.Ĭopying rootfs_overlay: /Users/elay15/projects/groxio/nerves/sensor_hub_poncho/sensor_hub/_build/rpi0_dev/nerves/rootfs_overlayĬopying rootfs_overlay: /Users/elay15/projects/groxio/nerves/sensor_hub_poncho/sensor_hub/rootfs_overlayĬreating 4.0 filesystem on /Users/elay15/projects/groxio/nerves/sensor_hub_poncho/sensor_hub/_build/_nerves-tmp/combined.squashfs, block size 131072.Įxportable Squashfs 4.0 filesystem, gzip compressed, data block size 131072Ĭompressed data, compressed metadata, compressed fragments,įilesystem size 28820.77 Kbytes (28.15 Mbytes)ĥ4.96% of uncompressed filesystem size (52439.72 Kbytes) * creating _build/rpi0_dev/rel/sensor_hub/releases/0.1.0/vm.args * skipping runtime configuration (config/runtime.exs not found) Usb is still running a connected usb drive $ export MIX_TARGET=rpi0ġ7:25:51~/projects/groxio/nerves/sensor_hub_poncho/sensor_hub I have been trying to find fixes all day that might help me reset my macOS USB connection. I use LanScan to see what’s connected to my mac network and it no longer picks up the pi 2 when I switch it on/off. Ssh command just hangs now as shown below…
I updated a change to the NervesMOTD function and did a mix upload and lost connection to the pi zero.īurned a firmware to a fresh sdcard and swapped over to usb cable and tried to ssh in to pi zero with fresh firmware. I had configured my Pi zero wifi connection after using the setup instructions in the build-a-weather-station-with-elixir-and-nerves_B4.0.pdf